Hello,
I have been trying to machine side 2 of a part designed and programmed in Fusion. Side 1 runs without an issue, but side 2 runs to the same point and stops with a "Z Soft Limit Overrun" Physically, the Z axis is nowhere near its limits. I have triple checked the setup and don't see anything wrong. I posted on the Autodesk Forum and after review of the PP and specific part file, they see nothing wrong with the code. Due to being a beginner with limited knowledge, I am stuck. I m...
Read more
I have been trying to machine side 2 of a part designed and programmed in Fusion. Side 1 runs without an issue, but side 2 runs to the same point and stops with a "Z Soft Limit Overrun" Physically, the Z axis is nowhere near its limits. I have triple checked the setup and don't see anything wrong. I posted on the Autodesk Forum and after review of the PP and specific part file, they see nothing wrong with the code. Due to being a beginner with limited knowledge, I am stuck. I m...
Read more