Hey all,
I'm trying to get a better surface finish via my 2" facemill, though I acknowledge some of it may just be machine/speed limitations.
Machine - Haas TM2P - 6000RPM
Cutter: https://www.haascnc.com/haas-tooling/package_kits/cutting_tool_kits/shell_mill_kits/08-0448.html which uses carbide positive octagon.
Cutting parameters:
![1707700286426.png]( "1707700286426.png")
DOC: was .008" on the last pass.
Stepover: 1.658"
I'm still learning about the various types of inserts, so admittely maybe these aren't...
Read more
I'm trying to get a better surface finish via my 2" facemill, though I acknowledge some of it may just be machine/speed limitations.
Machine - Haas TM2P - 6000RPM
Cutter: https://www.haascnc.com/haas-tooling/package_kits/cutting_tool_kits/shell_mill_kits/08-0448.html which uses carbide positive octagon.
Cutting parameters:
DOC: was .008" on the last pass.
Stepover: 1.658"
I'm still learning about the various types of inserts, so admittely maybe these aren't...
Read more