Hey y'all,
So recently I was handle jogging my UMC-350 to run a program and the spindle stopped because it entered a restricted zone. It spit out the 9108 error code. Now I can't move my axies in any direction with handle jog or any other way. I've already turned on setting 408 but I am still getting the same issue. Any help would be great.
So recently I was handle jogging my UMC-350 to run a program and the spindle stopped because it entered a restricted zone. It spit out the 9108 error code. Now I can't move my axies in any direction with handle jog or any other way. I've already turned on setting 408 but I am still getting the same issue. Any help would be great.