Hi Guys,
I was trying to get the information on CNC forum, unfortunately no results. Hopefully this subject oriented forum will have some answers for me.
The test part as per attached sketch (simplified ISO10791-7 TEST PIECE) was measured on Mitutoyo CMM.
I am not an expert in Mitutoyo CMM GEOPAK Inspection software. Seems that the report (attached too) was "cooked", as report Line Numbers are not following. Shouldn't they follow like 1,2,3,4 etc. Seems that the coordinate system was...
Read more
I was trying to get the information on CNC forum, unfortunately no results. Hopefully this subject oriented forum will have some answers for me.
The test part as per attached sketch (simplified ISO10791-7 TEST PIECE) was measured on Mitutoyo CMM.
I am not an expert in Mitutoyo CMM GEOPAK Inspection software. Seems that the report (attached too) was "cooked", as report Line Numbers are not following. Shouldn't they follow like 1,2,3,4 etc. Seems that the coordinate system was...
Read more