Hello,
So we are going to make samples of this particular component.
Final OD: 30mm
Final ID: 25 mm
Length: 10 mm
Slot width: 6 mm
Setup Sequence:
1) CNC Machining
2) Sloting on a SPM machine
My question is, will the part shrink when the slot is done, and if yes, by how much?
We made a bush of 40 mm diameter sometime back of EN1A material and OD and ID shrank by 50 and 80 microns respectively. We had to make a lot of iterations to get it right. What considerations and measures do we...
Read more
So we are going to make samples of this particular component.
Final OD: 30mm
Final ID: 25 mm
Length: 10 mm
Slot width: 6 mm
Setup Sequence:
1) CNC Machining
2) Sloting on a SPM machine
My question is, will the part shrink when the slot is done, and if yes, by how much?
We made a bush of 40 mm diameter sometime back of EN1A material and OD and ID shrank by 50 and 80 microns respectively. We had to make a lot of iterations to get it right. What considerations and measures do we...
Read more