Sodick AQ35L programming & shipping

Looking at an AQ35L. Upgrading from a manual Eltee. So this a major jump for us. Silly question: Is programming an AQ35 Sodick via RS-232, floppy, or at the control? Is it possible to edit/store job, electrode/material parameters? We do a lot of difficult materials (tungsten, niobium, high nickel steels etc..) And Flushing is always a challenge on nearly every job.

Can we use the 20mm Eltee tooling with adapters on the Sodick? Are there specific shipping lock fixtures/procedures we need for...

Read more