Hey all.
I'm making a part out of some 17-4 H900 SS. The feature I'm concerned about is a .850" diameter boss with a 2" radius on the top of it, similar to a section cut out of a hemisphere. I'm looking for a good surface finish here, but I'm also not looking to wait 20 hours for my machine to run through the program. I wrote the toolpaths a week ago, and looking at them again, I'm unsure if my numbers are gonna work
The tool i have to use for this feature is a 1/16" end mill. I have a...
Read more
I'm making a part out of some 17-4 H900 SS. The feature I'm concerned about is a .850" diameter boss with a 2" radius on the top of it, similar to a section cut out of a hemisphere. I'm looking for a good surface finish here, but I'm also not looking to wait 20 hours for my machine to run through the program. I wrote the toolpaths a week ago, and looking at them again, I'm unsure if my numbers are gonna work
The tool i have to use for this feature is a 1/16" end mill. I have a...
Read more