Hello, I'm new to this forum and this is my first post. So please bare with me.
I have a small lathe that I do hobby work on. It's a 10x22.
I do light rifle work mostly at center.
The bore is large enough to accomplish this.
Looking at my outboard spindle I noticed the spindle is crowded by the main drive pulley so I can't add a spider.
Any thoughts on a remedy?
It would be greatly appreciated.
Only lathe I can afford at the moment.
I have a small lathe that I do hobby work on. It's a 10x22.
I do light rifle work mostly at center.
The bore is large enough to accomplish this.
Looking at my outboard spindle I noticed the spindle is crowded by the main drive pulley so I can't add a spider.
Any thoughts on a remedy?
It would be greatly appreciated.
Only lathe I can afford at the moment.