Calibration of Renishaw probe in Mazak Matrix Nexus 2
Calibrated the probe after:
Indicating the probe true;
sweeping a known diameter ring & establishing it as a datum/work offset;
running the 'Calibrate' cycle in Mazatrol.
However, when I touched off my next workpiece with a 'Y-plus' surface routine, my offset was off by +.050" in 'Y'.
Any idea what I'm missing?
Calibrated the probe after:
Indicating the probe true;
sweeping a known diameter ring & establishing it as a datum/work offset;
running the 'Calibrate' cycle in Mazatrol.
However, when I touched off my next workpiece with a 'Y-plus' surface routine, my offset was off by +.050" in 'Y'.
Any idea what I'm missing?